You should have the correct side of the texture looking up, and push the shaded metal (top prong) through the texture and penetrate it – so the prongs stick through into the wrong side of the texture.
The shaded metal (top prong) ought to be based on the check you exited on the texture. For the Sandi ID wallet, the best prong and stud ought to be put on the best fold. press buttons for clothes While the base prong and attachment ought to be put on the base of the wallet
Crease you scrap texture fifty-fifty so you have a twofold layer to shield the painted shading metal top from your pincers.
Ensure the stud and shaded metal (top prong) are adjusted accurately.
Immovably press around the base of the stud (NOT specifically on the extending out studdy part but rather the base of the stud).
On the off chance that parts of the prong have not completely been pushed in you will have the capacity to tell once you pull a little on the texture as found in the photo beneath.
Press around the base of the stud once more.
Presently snatch the base prong and the attachment.
The attachment has two sides so the one on the privilege is the means by which you need it to be put, generally the stud and attachment will be somewhat free. In the event that you are uncertain simply snap them to each other and retain which side of the attachment fit – I do it as often as possible and afterward forget which side was right and wind up triple checking the fit like a minor OCD propensity.